Hello !
I just recently purchased the Brain V2 starter kit. I am new to electrical engineering type shtuff, but I am already loving the system!
However, I have ran into quite a curious snafu. I hooked up some arcade buttons, and they worked. So I went into the Brain V2 Configure program to browse around. I went to tools and saw that the Brain was sending non stop CC data. As below.
I unhooked the arcade buttons, rebooted, unplugged everything, replugged everything. (The level 1 solutions)
But still it sends data... even without any buttons attached.
I have searched around the forums a bit, but couldn't find the exact solution yet.
So a few questions I guess
- Is this a common error? fixable?
- Could the board be busted? Or human error? Firmware?
I have the double decker board thing sandwiched together, and simply hooked up via USB. No arcade buttons hooked up.
Here are my config settings
Any clues would be greatly appreciated. Thanks!