OHMRGB and LUMINAIR 3

New user here.  Don't even have my OHMRGB  yet, it's en route.  =)

I want to use it with a new iPad Air 2, running Luminair 3 to control DMX lighting for my bands.  Similar to what is done here-

http://support.synthe-fx.com/customer/portal/articles/2029571-using-the-livid-ohm-midi-controller-with-luminair

The first thing I would like to be able to do is run a row of the "clip buttons", say 1-8, in what I would call "monophonic" mode.  I would like to have them all set to different colors and only have one active at any time.  So say I push button 1 my stage will light up red and the LED associated with button 1 should come on (whatever color I program it I presume).  Then when I push button 2 the stage will turn blue, and the LED for button 1 should come off and the LED for button 2 should come on.  Thus at any given time only ONE clip button is on and illuminated, and it that one is the last one that was pressed.  Like a mono synth that can only do one pitch at a time.

Is that possible?

I'd also like to do the above, but for smaller ranges of buttons.  So say I want 4 different strobe scenes that are only available one at a time, I might want to set up clip buttons 25-28 to only light up one at a time, and only the last one pressed.

Any help or advice appreciated.  My unit should be here in 2-3 days and I'll start working with it.

Richard/krebsne