Ohm64 with M-PC

Hey Everyone,

I am trying to use the Ohm64 (not RGB) controller with Martin M-PC software to control lights.

I am able to see/control the Ohm64 with the Ohm64 Editor software. I cannot, however, get it to communicate with M-PC. I am using Windows 8 on an Asus touchscreen laptop.

I have done a lot of research and most people say I need to use something like Midi-Yoke or Midi-Ox as a software translator between the Ohm and M-PC.

I am unfamiliar with Midi programming/mapping so I am not sure what steps to take to get the system working.

I understand that many of you probably haven't dealt with the specific situation I am in, but if anyone can give me a direction to go towards I would greatly appreciate it.

Cheers,
Matt