Hello everyone,
I recently purchased an OHM RGB off of ebay in order to create, what I thought would be my dream controller for a live PA setup. Unfortunately the dream has turned into a nightmare. I have 3 machines I'm wanting to control with the OHM RGB, an Akai MPC 2500, an Elektron Octatrack and an Elektron Analog 4.
The setup was supposed to be like so:
OHM RGB -> MPC input 2 -> and then from the MPC to Ocatrack via midi out 1 of MPC and Analog 4 via midi out 2 of MPC.
That said I can't even trigger track mutes from the OHM RGB to the MPC. I am trying to use the 64 "clip bank" buttons in the center to to trigger track muting and unmuting on the mpc. The MPC does have an area were I can assign a Midi note to a pad in order to mute it, but when I press "clip bank" buttons on the OHM RGB they always seems to trigger the same note on the MPC, C_0... Also some buttons send Bend signals to the MPC.
How can I properly program this thing so that it sends a specific note per pad? or is the MPC not capable of recognizing this, it seems like it should.